M-Spa OASIS Owner's Manual download pdf (Page 20)

PROGRAMMABLE FILTER TIMES

F1: 45 minutes F2: 2 hours F4: 4 hours F6: 6 hours

•To adjust the filter time: First press the TEMP SET pad, then press the ZONE 1 JETS.

•Press TEMP SET pad again to scroll through the filtration options as shown above

(F1, F2, F4, or F6).

•When you have selected the time you want, press the ZONE 1 JETS pad to enter.

The display will then show either 1C or 2C for 1 Cycle or 2 Cycles per 24 hour

period.

•Press TEMP SET pad to adjust for the frequency you want and then ZONE 1 JETS

pad to enter the selection and exit the programming mode.

NOTE: In event of a power outage, all settings will revert to the preset, default settings.

TEMPERATURE DISPLAY AND ADJUSTMENT

The LCD window displays the actual water temperature. Pressing the TEMP SET pad will

make the numbers flash, then pressing the pad again (repeatedly) will increase the set

temperature one degree at a time, up to 104° F. After a short pause, the actual

temperature will again be displayed. Repeating the above procedure will allow you to

decrease the set temperature.

SOAK TIMER AND SOAK FEATURE

Pressing the SOAK TIMER pad will turn the jet pump to low-speed and start a 59-minute

timer. The timer will display the elapsed time in one-minute increments (1-14). After 15

minutes, the display will flash the minute (15-59) for ten seconds before switching to a

steady display as a safety reminder to not overstay your soak. During the Soak Timer

mode, the temperature display can be checked by pressing the TEMP SET pad.

A second press of the SOAK TIMER pad will turn off all functions (except light) for an all-quiet

soak. Pressing any pad will cancel the Soak mode.

HEAT LIGHT

The HEAT ON light will illuminate when the heater is on.

LCD DIAGNOSTIC MESSAGES

The advanced technology built into the spa allows it to perform a number of self-

diagnostic system checks and it can display a variety of messages on the LCD panel. See

TROUBLESHOOTING section for descriptions.

MAINTENANCE REMINDERS

Maintenance Reminders help remind you of routine maintenance procedures.

CL: Will appear every 30 days to remind you to clean the filter.*

CH: Will appear every 90 days to remind you to change the spa water.*

*NOTE: In event of a power outage, all settings will revert to the preset, default settings.

REMOTE CONTROL

Optional Remote Control operates exactly the same as the Leisure Series Control.

LEISURE SERIES CONTROLS

MARQUIS SPAS • RELAXING YOUR WORLD 17

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 57 58

No comments

M-Spa OASIS Owner's Manual Page 20