M-Spa OASIS Owner's Manual download pdf (Page 13)

THERAPY PUMP(S)

Allow the spa to circulate on high-speed (see instructions for spa side controls) for 4-5

minutes to discharge air from the plumbing system. Do not expect hot water immedi-

ately from the jets; the heater will take several hours to heat the water.

Pr Diagnostic Message

NOTE: Coastal and Ultimate Series spas have a “pump priming” feature which begins

at start-up. When the spa is energized, the LCD panel will display a “Pr” message. This

mode will last approximately four to five minutes if not exited manually. To exit manually,

press the TEMP SET pad. At this time the spa

should have water flowing from the jets. If the

pump has not primed and water is not flowing

from the jets after two minutes, TURN OFF

POWER TO THE SPA. Vent air from the

pumps by slightly opening the pump unions (see

TROUBLESHOOTING section, Water Flow).

After turning the power on again, the spa will

initiate a new priming mode. Repeat steps above.

After you have manually exited the priming mode (or you allowed the spa to automati-

cally exit) the LCD display will momentarily display 100° F and then the display will

switch to - -° F. The system requires approximately one minute of water flow to

determine the water temperature. After one minute of water flow, the temperature will

be displayed as 65° F. Press the TEMP SET pad to adjust the desired set temperature for

the spa.

NOTE: Your spa has been filled and test-run at the factory. The first time your spa is

filled with water, some discoloration from residual test water may appear. This will

disappear when the spa is completely filled and the filtration system is functioning. Test

the water for the proper chemical balance and adjust as necessary. PROPER CHEMI-

CAL BALANCE IS IMPORTANT.

SAFETY ENERGY COVER

When the spa is not in use, the safety energy

cover should be kept on the spa to retain the water’s

heat and to keep out dirt, leaves, etc. Your heater

will maintain a constant water temperature between

spa uses.

For your safety and convenience, the cover is equipped

with safety locks. Marquis suggests that you use them

to help keep out unintended users and prevent covers

from being blown off in high wind conditions. For

Secure Straps, see your Marquis Dealer.

OPERATING YOUR SPA

MARQUIS SPAS • RELAXING YOUR WORLD 10

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 57 58

No comments

M-Spa OASIS Owner's Manual Page 13