M-Spa OASIS Owner's Manual download pdf (Page 12)

STARTING YOUR SPA

MARQUIS SPAS • RELAXING YOUR WORLD 9

START-UP PROCEDURE

Your spa is equipped with solid state preprogrammed Comfort Controls specific to your spa

model. Please see the CONTROLS section listed under your particular spa series model.

To start your spa, you will need a spa chemical test kit and an underwater thermometer.

It is important to follow each of these steps when starting your spa.

Leisure and Recreational Series Models Start-up:

1. Place spa on a hard, flat, level surface. Make sure the

power supply is off.

2. Make sure that the suction fittings in the footwell are

in place and undamaged.

3. Open the equipment door. Screw the pump plug

(supplied in packet) into the face of the pump. Close

the drain valve and screw the drain valve cap on

tightly. Tighten all disconnects and open all shut-off

valves. On models equipped with AWP external drain,

close valve by turning outer ring clockwise. Be sure

center plug is in place and tighten.

4. Fill the spa with water to two-thirds of the way up the

Vortex skimmer opening(s).

5. Turn the power on and wait five seconds.

6. At this time the spa should have water flowing from the

jets. If the pump has not primed and water is not

flowing from the jets after two minutes TURN OFF

POWER TO THE SPA and vent air from the pumps

by slightly opening the pump union. (See TROUBLE

SHOOTING section, Water Flow.)

7. Your spa water temperature is preset at 100° F. Use the TEMP SET pad on the

bather’s control panel to set the water temperature to the desired level.

8. SHOCK SANITIZE the water and test the water chemistry following the instruc-

tions in your chemical test kit.

9. Place the cover on the spa. It will take 12 to 24 hours for the water to heat to set

temperature.

10. Check the water temperature and adjust the setting if necessary. Normal use

is between 98° and 102° F.

Coastal and Ultimate Series Models Start-up:

Follow steps one through three of Leisure and Recreational Series Models Start-up.

4. Check to make sure the freeze line is properly connected.

Follow steps five through ten of Leisure and Recreational Series Models Start-up.

Pump Union

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 57 58

No comments

M-Spa OASIS Owner's Manual Page 12