8
DO NOT OVER INFLATE. OVER INFLATION MAY CAUSE SPA POOL LEAKAGE AND VOID THE MAN
UFACTURER WARRANTY.
h) If over inflated, press the “bubble” button again to stop inflating. Remove the inflation hose from the air valve on
the spa pool. Screw the cover to the valve once the air pressure inside the pool is tested to be suitable.
i) Connect the inflation hose to the air valve of inflatable bladder(optional) and then press the “bubble” button on
the control panel to inflate it. When it’s going to be full without wrinkles on surface, please press the “bubble”
button again to shut off and stop inflating.
j) Water Filling
muminim dna mumixam eht fo neewteb ni eb tsum level retaW .retaw htiw but aps eht llfi ot esoh n
edrag a gnisU
water lines printed inside the spa wall.
WARNING:
1. Fill in water carefully especially for the first time of use. Water level must reach the minimum water line
but not exceed the maximum water line, otherwise it may cause pump failure.
2. Please avoid water spillage which will cause damage to the electric parts.
3. After filling in water, please check air pressure again and make sure the green section appears on the manometer.
when the spa needs to be inflated more, always make sure the manometer reaches the green section. When
needs to inflate more air during use, please make sure it reads in green sector in any term.
4. Please reduce the air pressure to the yellow sector of manometer, to avoid over inflation due to warm weather or
sunshine etc. after leaving Mspa for weeks inflated.
Warning: to avoid function failure and damage to the control system, please do not operate until spa is filled
with water to the minimum water mark.
k) Place the zipper cover onto the spa and then put the inflatable bladder onto the spa pool, Fasten the zipper and
lock the cover to the spa by using the digital lock in the accessory pack.
Note: Please remember to test and adjust the air pressure inside of spa pool before each time of use.
Please cover zipper with wax once a week so as to make it smooth for operation and avoid split.
Note: For B-091 , place the top lid onto the spa, connect to ground
cloth by buckle for heating or safety when not in use.
How to change the combination of digital lock:
Original combination is set as 000
1) Push the release button(a) in the direction of the arrow shown and the lock
will be released.
2) Set your desired combination by move the number wheel(b).
Please do not forget to press your new combination.
3) Insert back the steel cable(c) to its end in the direction of the arrow. The
new combination is ready for use.
WARNING: Do not move the number wheels while the digital lock is open. Or you will change the
combination you just set. This will unable the digital lock.
WARNING: The cover is not a substitute for adult supervision; Children must be supervised at all times
around the spa tub.
WARNING: Water attracts children; Always attach the spa cover and lock it after each use.
(j) (k)
For B-091 Only.
(a)
(b)
(c)
(1)
)3()2(
*
*
(17 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals