9
POWER PACK OPERATION
Warning: to avoid function failure and damage, please do not operate until spa is filled
with water to the minimum water mark.
It is the owner’s responsibility to make sure the installation conditions are met and the following
safety and warning rules are exercised. Any failure and damage which result from dry-run, water
spillage, excessive humidity, or structural loading will void the warranty.
Control Panel Instruction:
“ON/OFF” Button: Default stand by mode shows
red when the power is on. Press again, the
control reaches operative mode and turns
to green. The power consumption of the
stand by mode is within 0.5W.
1. “BUBBLE” Button: To activate Bubbling
function. The bubbling system has a 20-minute
operation auto shut down for 10-minutes feature.
The light of Bubble button is on when being activated.
Note: If the Bubble function works for over 15 mins and is stopped manually, you
will need to wait for 10 minutes to activate the Bubble function again.
2. “FILTER” Button: To activate Filtration system.
The light of “FILTER” button is on when the filtration system is activated.
3. “HEATER” Button: To activate Heating and Filtration system at the
same time. (Filtration system cannot be turned off when heating)
4. TEMPERATURE “UP” Button: Increase temperature
5. TEMPERATURE “DOWN” Button: Lower temperatrure
4 5
3 2 1
NOTE: The set temperature defaults to 38°C be in operative mode.
NOTE: Temperature can be adjusted between 20°C and 42°C.
When pressing “TEMPERATURE ” for 3 seconds, LED starts to flash and then you can set
your desired temperature by pressing up “ ” and down “ ” buttons. After temperature is set,
you may press the temperature button again or leave it for 10 seconds and then it’ll display
current water temperature.
NOTE: In case when leaving spa under unattended working condition, you can press down " ”
then up “ ” buttons to lock the control panel to avoid any wrong operation by children.
To unlock, press down“ ” then up “ ” buttons again, it unlocks after "D" sound.
The "HEATER" button displays green color by press, later turns into red automatically after 10
seconds when the heating system is activated.
NOTE: It’s normal that filtration system cannot be turned off individually when it is working.
NOTE: Filtration function can only be turned off by pressing “HEATER” button but not
“FILTER” button.
The heater will be stopping heating until the current water temperature reaches the set
temperature. After the set temperature is reached, the “FILTER” button will be off and “HEATER”
button shows green. After the current water temperature drops 2°C below the set temperature,
the heating system will restart and light turns into red. The “FILTER” button will be activated
automatically at the same time. The heat increase rate is maximally 1.2 to 2.5°C per hour.
Please note that the following conditions will lead to slow heating without heating phenomenon:
1. Environmental temperature lower than 10°C
2. Outdoor wind force above Gentle breeze/F 3
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals